No results were found for the filter!
This special Transrotor tonearm board is for the Reed H1, right side - 10,5 inch tonearm and fits on the existing 9 inch tonearm base.
This special Transrotor tonearm board is for the Reed H1, right side - 10,5 inch tonearm and fits on the existing 9 inch tonearm base.
This transrotor for tonearm is provided for the SME 309 tonearm and is only suitable for the Zet 3 turntable. Assembly is carried out using an Allen screw provided. Photo 1 is the view from above. Photo 2 is the view from below....
This transrotor tonearm base is suitable for each SME 9 "reading arm on a Fat Bob S TMD Transrotor vinyl turntable
This transrotor tonearm base is suitable for each Jelco 9 "tonearm on a Zet 3 transrotor turntable.