Ortofon 2M Black
The cartridfge Ortofon 2M Black is the high-end cartridge of the 2M range and is equipped with a Shibata tip.
The philosophy of Ortofon is to render as accurate as possible the sound recorded on the disc, without coloring or deforming the sound.
The new 2M series is the culmination of a long search for a very high performance mobile magnet cartrdige, both in terms of the response curve and the level of musicality. The name 2M comes from the MM of Mobile Magnet. The design was entrusted to Copenhagen's Møller Jensen Design, the same designer who designed the Kontrapunkt series.
The 2M Black uses a bare Shibata diamond. 2M technology is based on a split magnet magnetic motor to reduce eddy currents. This makes it possible to obtain an extremely flat response curve. The quality of this magnetic assembly gives it a remarkable sensitivity of 5mV.
A high-end MM cartridge.
This cartridge is available in three versions, 2M Black, 2M BlackVerso and 2M Black PNP MKII.
2M Black / classic version.
2M Black Verso / version with screw outwards.
2M Black PNP MKII / Version integrating the cartridge holder designed only for the 2M range with connector to SME standards.
Technical specifications:
- Cartridge type: MM (Moving-Magnet)
- Output voltage: 5 mV *
- Preamp Output: Phono MM
- Balance between channels at 1 kHz: 1 dB
- Channel separation at 1 kHz: 26 dB
- Channel separation at 15 kHz: 15 dB
- Bandwidth: 20-31.000Hz
- Frequency response: 20-20,000 Hz + 2 / -0 dB
- Reading capacity at 315 Hz: 80 μm **
- Lateral compliance: 22 μm / mN
- Tip Type: Shibata nude
- Diamond radius: r / R 6/50 μm
- Bearing force range: 14-17 mN (1.4-1.7 g)
- Recommended support force: 15 mN (1.5 g)
- Angle of attack: 20 °
- Internal impedance: 1.2 kOhm
- Internal inductance: 630 mH
- Recommended load impedance: 47 kOhm
- Recommended load capacity: 150-300 pF
- Case construction: Noryl
- Weight of the cartridge: 7.2 g
- Particularity: Silver plated coil; OFC-Copper
- Replacement Diamond: Diamond 2M Black
- Weight version PNP MKII 23 g
* at 1000Hz, 5cm / sec. ** with recommended support force Version 2M - screw mounting from above. Version 2M Verso - Bottom mounting with interchangeable threaded pins (diameters 2 and 2.5mm). Suitable for eg many Thorens vinyl turntables. Integrated PnP Headshell Version 2M with con