Ortofon 2M Red MM
Ortofon 2M Red is an MM cartridge designed for precise and accurate recovery of information in the grooves.
The philosophy of Ortofon is to restitute as accurate as possible the sound recorded on the disc, without coloring or deforming the sound.
The new 2M series is the culmination of a long quest to obtain a mobile magnet cartridge with very high performance, both in terms of the response curve and the level of musicality. The name 2M comes from the MM of Mobile Magnet. The design was entrusted to Copenhagen's Møller Jensen Design, the same designer who designed the Kontrapunkt series.
The 2M Red uses a chimney elliptical diamond. 2M technology is based on a split magnet magnetic motor to reduce eddy currents. This makes it possible to obtain an extremely flat response curve. The quality of this magnetic assembly gives it a remarkable sensitivity of 5.5mV.
This cartridge is available in three versions, 2M Red, 2M Red Verso and 2M Red PNP MKII.
2M Red / classic version
2M Red Verso / version with screw outputs up
2M Red PNP MKII / Version integrating the cartridge holder designed only for the 2M range with connector to SME standards
Technical specifications:
- 1/2 "mount - Elliptical - Mobile Magnet
- Output level at 1000 Hz, 5 cm / sec: 5.5 mV
- Balance between channels at 1 kHz: 1.5 dB
- Channel separation: 22 dB (1 kHz) - 15 dB (15 kHz)
- Frequency response: 20-22,000 Hz -3 dB
- Frequency response: 20-20,000 Hz + 3 / - 1 dB
- Lateral compliance: 20 μm / mN
- Diamond Type: Elliptical Nude
- Diamond radius: r / R 8/18 μm
- Supporting force: 1.6-2.0 g (16-20 mN)
- Recommended support force: 1.8 g (18 mN)
- Angle of attack: 20 °
- Internal impedance: 1.3 kOhm
- Internal inductance: 700 mH
- Recommended load: 47 kOhm / 150-300 pF
- Weight of the cartridge: 7.2 g
- Weight version PNP MKII 23 g
- Replacement Diamond: 2M Red
* at 1000Hz, 5cm / sec. ** with recommended support force Version 2M - mounting with screws from above. Version 2M Verso - Bottom mounting with interchangeable threaded pins (diameters 2 and 2.5mm). Suitable for eg many Thorens vinyl turntables. Headshell PnP integrated version 2M with SME connection.