Audio-Technica AT-VM95E / H Mounted on a cartridge holder AT-HS6
- Article number: 104311
The Audio Technica AT-VM95ML / H cartridge is mounted on an AT-HS 6 cartridge holder, the new AT-VM95E Audio-Technica cartridge replaces the well-known AT95E and uses the development of the AT-95EX introduced in 2015. With an improved and impressive design, there are two threaded inserts in the case; thus, it is possible to fix two screws without nut on the cartridge holder or on an associated reading arm.
Update compatible with compatible replacement needles: conical, elliptical, elliptical nude, microlinear, shibata and shellac.
Glued elliptical stylus
The elliptical diamond tip follows groove modulation with greater precision than a conical tip and offers improved frequency and phase response while reducing distortion.
VM95 cartridges are equipped with two M2.6 threaded inserts that allow the system to be mounted in the tonearm or on a cartridge holder without the use of nuts. Each sensor is equipped with a pair of 8.6mm M2.6mm screws, a pair of 11.6mm M2.6 screws and two plastic discs.
- Aluminum cantilever
- Output voltage of 4.0 mV
- Body compatible with all styli of the VM95 series
- Replacement for AT95E and AT95EX
- Frequency response from 20 to 22,000 Hz
The images of the Audio Technica AT-VM95E cartridge were created on 28.11.18 and are protected by copyright.
- Model AT-VM95E
- Type VM double stereo magnet
- 1/2 "mounting
- Frequency response 20 - 22,000 Hz
- Channel separation 20 dB (1 kHz)
- Output channel balance 2.0 dB (1 KHz)
- Output voltage 4.0 mV (at 1 kHz, 5 cm / dry)
- Vertical tracking angle 23 °
- Weight 1.8 - 2.2 g (standard 2.0 g)
- Polished Elliptical
- Needle size 0.3 x 0.7 mil
- Needle construction
- Cantilever aluminum tube
- Coil impedance 3.3 kΩ (1 kHz)
- 550 mH (1 kHz) coil inductance
- DC resistance 485 Ω
- Static chord 17 x 10 - 6 cm / dyn
- Dynamic matching 7 x 10 - 6 cm / dyn (100 Hz)
- The coil wire uses copper TP
- Recommended load impedance 47,000 Ω
- Recommended capacity 100-200 pF
- Weight 6.1 g
- Dimensions 17.2 x 18.9 x 28.3 (H x W x D mm)
- AT-VMN95E Replacement Needle
- Accessories included Two 11mm installation screws; Two 8 mm installation screws; Two washers
